DropOS

Overview These GNSS modules are built around the UBX‑M10050‑KB chip, supporting concurrent multi‑constellation reception for GPS, GLONASS, Galileo and BeiDou. Capable of tracking over 50 satellites simultaneously, the receiver picks optimal satellite signals to deliver reliable positioning, even in complex urban canyon environments. It supports dual‑protocol output: NMEA‑0183 and UBX. Standard positioning update rate is 10 Hz, with maximum 25 Hz supported. Equipped with a high‑gain antenna featuring omnidirectional radiation pattern, it ensures excellent GNSS performance and grants higher flexibility for equipment mounting. Model Note: M10SD, M10FLY and M10FD come with onboard QMC5883L magnetometer.G10A‑F30 does NOT include magnetometer. Perfect for FPV drones, robots, marine vessels, speedometers and other projects. Fully compatible with mainstream flight controllers including ArduPilot, INAV, Betaflight, Pixhawk, APM. It delivers substantially better performance than legacy M8N modules. Powered by the UBX‑M10 high‑precision GNSS platform, the chip achieves outstanding sensitivity and fast signal acquisition across all L1‑band GNSS signals. Continuous‑tracking mode features ultra‑low power draw, extending battery life for battery‑powered devices like asset trackers without sacrificing positioning accuracy. UBX Super‑S (Super‑Signal) technology boosts RF receiving sensitivity, improving dynamic positioning accuracy when using small‑size antennas or operating under non‑line‑of‑sight conditions. Specification G10A-F30 M10SD M10FLY M10FD Pin Description Compass Settings Guide Supported GNSS Constellations UBX-M10050-KB is a concurrent GNSS receiver that can receive and track multiple GNSS systems. The single RF front-end architecture enables concurrent reception of multiple GNSS constellations. The receiver can be configured for a subset of GNSS constellations to achieve lower power consumption. The factory configuration on these modules is concurrent reception of GPS, Galileo, GLONASS and BeiDou B1C with QZSS and SBAS enabled. The following GNSS and their signals are supported: Supported Protocols For more details, please refer to official documents. Dynamic Platform The dynamic platform model can be configured through the CFG-NAVSPG-DYNMODEL configuration item. For the supported dynamic platform models and their details please refer to the table below. The default dynamic model is Portable. Factory Settings G10A-F30: •GPS+Galileo+GLONASS+BeiDou+QZSS+SBAS •38400 baud, 8 bits, no parity bit, 1 stop bit. •1Hz navigation update rate. •1PPS time pulse •NMEA version 4.11. •Input messages: NMEA and UBX. •Output messages: NMEA GGA, GLL, GSA, GSV, RMC, VTG and TXT. M10SD M10FLY M10FD: •GPS+Galileo+GLONASS+BeiDou+QZSS+SBAS. •115200 baud, 8 bits, no parity bit, 1 stop bit. •High performance mode. •10Hz navigation update rate. •Input messages: NMEA and UBX. •Output messages: NMEA GGA, GLL, GSA, GSV, RMC, VTG and TXT./UBX-NAV-PVT Performance Details